As we have increased our number of bikes over the years we’ve had to look for a different method of storing them in the garage.

Yes, despite the fact that I LOVE bikes, they are still relegated to the garage. Before getting the Steadyrack bike racks we used two upright racks that held two bikes each. They worked fine, although with heavier bikes it could be difficult to lift the bikes overhead to place them on the rack.

My partner-in-crime aka Mark researched bike racks and considered the pros and cons of numerous types. When he found the “Steadyrack” neither of us had ever seen nor heard of them before. They seemed like the best way to go so he ordered them through Amazon and in two days we had them. The cost of each rack was $67.

Here is a video of the Steadyrack system:

Pretty cool isn’t it.

Once the wall was reinforced the racks were pretty straightforward to install. The instructions are very clear on how to install them and the formula you use to space the racks (depending on the handlebar width) is also straightforward. The bikes hang about two inches from the floor.

The rack is one piece with an additional plastic holder mounted at the bottom to hold or brace the wheel – depending on whether the bike is at 90 degrees or pivoted to either side. Regardless if you rest the bottom wheel in the “cup” or against it, the wheel and bike are steady. The rack holds the bike securely in place.

We have six bikes in roughly the same amount of space we had four bikes. With the bikes perpendicular to the wall they do stick out a little further than our original rack.

If you want the bikes to stick out less, no sweat just pivot the bikes to the side, and they lay more “flush” against the wall. The rack pivots from side to side almost 180 degrees allowing for great flexibility in placement of your bike.

How easy is it to use? Amazingly easy. You simply tip your bike up balancing it on the back wheel, roll the bike to the rack and slide the front wheel into the rack. As the wheel goes into the rack, the bike lifts, (you don’t have to lift it) and the back tire rests in the bottom holder. To get the bike out I pull the bike towards me and without much effort the bike comes out of the rack. The video shows how easy it is to get the bike in and out of the rack.

Steadyrack reportedly fits most bikes including 29’rs. Another plus is it protects your frame from getting nicked up since no part of the frame comes into contact with the rack. Most important: it’s easy to use and we still have room to add two new bikes.

Steady Rack’s slogan is “Love Your Bike” which I rather like… I love their bike rack too.

What’s a Hoo-Rag you ask? Basically a Hoo-Rag is a tubular, seamless bandana made out of a cotton/poly blend that can be used in a variety of ways – by a variety of people – including cyclists.

The Hoo-Rag can be worn under a helmet to provide a little extra warmth or keep your hair out of your eyes. I’ve found when I slip it over my head without bunching up the fabric, the excess blocks the vents in my helmet keeping me warmer.

As you can see from the picture, it can also be worn after the ride as a headband, pony tail holder or head covering to cover up “helmet hair”.

It comes in a variety of designs and can be worn by women or men in a myriad of ways. For more information or to order, visit:  www.hoorag.com.

Thanks to Hoo-Rag for providing me with this versatile product.